How to tie the ears of a German Shepherd puppy? First clean the ears of the German Shepherd puppy, then wrap the cotton strips with tape, stuff the cotton strips into the ears of the German Shepherd puppies, unfold the ears and wrap them on the positioning cotton strips; then use tape to cover the head Wrap it in the direction of the head, do not tie it too tightly; then wrap a long piece of tape around the base of the ear, then pass it through the top of the head, and tie the other ear in the same way.

Materials required:

Johnson's tape, athlete's tape, or a similar breathable tape. Domestic paper-based wide medical tape is also available.

The tape is about 2 cm wide

Two balls of hemostatic Danbis cotton strips (sized to fit your dog’s ears)

Scissors

An assistant

Preparation work:

Use canine clean water or peroxide to clean your puppy's ears thoroughly. When the ears are dry, you can prepare cotton balls, and tape. Tear the cotton ball and twist it into a strip. Wrap the cotton strip with tape.

Next step: You need to apply tape to the cotton sliver. In other words, you need to wrap the tape around the cotton sliver with the adhesive side facing out. Start at the top of the tampon and wrap it with tape in one go, then, turn it upside down and wrap it around, spiraling down the tampon like a hairdresser would do.

Next, cut a few pieces of tape about 6 inches long and place them within easy reach.

Now you can prepare the puppy and have the assistant control it firmly so that it does not twist too much.

Positioning:

Take a tampon and insert it into your ear at an appropriate depth without using excessive force. Then, unfold the ear and wrap it around the positioning tampon. Find the natural fold in your puppy's ears, which is important for ear support. Never unfold the pleats when tying them in school. Your puppy's ears need this fold to provide support to stand upright.

Begin to dip your ears into the positioning sliver. Start as low as possible (this is important to prevent the tampon from falling out), wrapping it toward your head and then around your back. Be careful not to wrap it too tightly. Adequate gluing is important, but it doesn't need to be super tight.

Next you need to tie the top of the ear, being careful not to finish the tip. Again: don’t tie it too tight, you will cut off the blood circulation and the tip of the ear will become necrotic.

For the last step you will need to support your ears. Wrap a long piece of tape around the base of the ear, then across the top of the head, wrapping the other ear in a similar manner. The ears should stand vertically. There should be no leaning towards either side.

It can be disassembled every 1 to 3 days for 1 to 8 hours, so that it can be erected in about a month.